[FR] Add Esp32 PCF8575 library about marlin HOT 4 OPEN

The command set that this library should have ready is as follows:
M64 P0.4 pin open immediately for pin control
M65 P0.4 pin close immediately for pin control
Pin status wait M66 P0.4
In this way, the command is Linux-CNC compatible, and Marlin provides international Gcode file compatibility, meaning that a Gcode written for Linux-CNC will work without any problems.

from marlin.

https://linuxcnc.org/docs/devel/html/gcode/m-code.html
A Marlin regulation compatible with these standards should be made so that the 3D Gcode set should now be its own standard. There are conflicts, which causes problems when you want to use Marlin as a CNC lathe. 3D Gcodes should be taken out of the previously determined Linux, CNC and Fanuc standards. If this happens, Marlin will have more power over these two NC systems. makes it like

from marlin.

Adding this feature in a healthy way will completely eliminate the pin restriction issue of a wonderful processor like ESP32 and make it extremely flexible. This chip is a 16-bit chip and can be addressed up to 8, which means a total of 128 pins from 8x16 to be used as both input and output is a good enough event.

from marlin.

@hsyngndz85: It would be really helpful if you could translate your comments to English since that is the primary language used for this project.

from marlin.