measurements, Y axis about prusa_i3_bear_upgrade HOT 3 CLOSED

Thank you so much for the compliments, this is really helping me!

On the original MK2(s) those measurements are done from top of the rod holder, not from of the rod hole. It is difficult to explain, hope you understand. You can also have a look on this drawin for the MK2 : https://raw.githubusercontent.com/PrusaMK2Users/MK2_Tips_and_Tricks/master/Prusa-i3-mk2-Dimensions.png

If you carefully check the rod holders, they are just a bit bigger than the 20mm (width of the vslot), this is to have the exact same dimensions as the MK2(s) (rod hole is 9.75 long and between front of the hole and front of the piece you have 9.50).

However, I did two different piece from back and front and that is wrong. I didn't remember why I did this and there is effectively an issue! Thanks for that, will fix it today :)

from prusa_i3_bear_upgrade.

So I remember why I did different front and back rod holders. This is because the frame is not 6mm thick but more 6.2-6.3mm on mine. So, on the original, you have 185 only if you have a frame that is 6mm, otherwise you will compensate the difference by screwing a bit more on the rod.

I will make all rod_holders the same and the difference will be compensated when screwing in the vslot.

from prusa_i3_bear_upgrade.

01bf853

from prusa_i3_bear_upgrade.