Failing XYZ Cal about prusa_i3_bear_upgrade HOT 2 CLOSED

Looks like it is not a firmware issue then and with all clone hardware it is hard to debug. A common issue is that the clone bed doesn't have properly designed probe circle and it is causing issue but I can't confirm this is your case.

from prusa_i3_bear_upgrade.

Any way to test that? If I can confirm, I can take it up with the seller.

EDIT:
I've tried three different beds and two different PINDA V2 probes. Result is the same. What else should I look at?

EDIT 2:
Found the problem! I was using this mod but didn't move the Z axis back! I was supposed to use the included Z-helper to adjust. That was an incredible pain to find out what the issue was--the error message should be more indicative. That's not your fault though, you can close this and I'll try to help them fix it upstream at Prusa. The XYZ cal fail needs WAY more verbiage--there's about a trillion things that will give you the exact same message.

from prusa_i3_bear_upgrade.