AIM:

To implement JK flipflop using verilog and validating their functionality using their functional tables

SOFTWARE REQUIRED:

Quartus prime

THEORY

JK Flip-Flop

JK flip-flop is the modified version of SR flip-flop. It operates with only positive clock transitions or negative clock transitions. The circuit diagram of JK flip-flop is shown in the following figure.

This circuit has two inputs J & K and two outputs Qtt & Qtt’. The operation of JK flip-flop is similar to SR flip-flop. Here, we considered the inputs of SR flip-flop as S = J Qtt’ and R = KQtt in order to utilize the modified SR flip-flop for 4 combinations of inputs. The following table shows the state table of JK flip-flop.

Here, Qtt & Qt+1t+1 are present state & next state respectively. So, JK flip-flop can be used for one of these four functions such as Hold, Reset, Set & Complement of present state based on the input conditions, when positive transition of clock signal is applied. The following table shows the characteristic table of JK flip-flop. Present Inputs Present State Next State

By using three variable K-Map, we can get the simplified expression for next state, Qt+1t+1. Three variable K-Map for next state, Qt+1t+1 is shown in the following figure.

The maximum possible groupings of adjacent ones are already shown in the figure. Therefore, the simplified expression for next state Qt+1t+1 is Q(t+1)=JQ(t)′+K′Q(t)Q(t+1)=JQ(t)′+K′Q(t)

Procedure

step-1 Go to quartus software.

step-2 Set new environment.

step-3 Type the code to implement SR flipflop using verilog and validating their functionality using their functional tables.

step-4 Run the program.

step-5 Give inputs in the waveform table .

step-6 Run the program.

PROGRAM

/* Program for flipflops and verify its truth table in quartus using Verilog programming. Developed by:Zafreen J RegisterNumber:212223040252 */

module JKFLIPFLOP(q, qb,j,k,clock,reset);
    input j,k,clock,reset;
    output reg q, qb;
	 
always @ (posedge (clock))

    begin 
        if (!reset)
            begin
               q <= q;
               qb <=qb;
            end   
        
else
   begin
	   if(j==0 && k==0)
		   begin
			q<=q;
			qb<=qb;
			end
		else if(j!=k)
		   begin
			q<=j;
			qb<=k;
			end
		else if(j==1 && k==1)
		    begin
			 q<=~q;
			 qb<=~qb;
			 end
	end
end	
endmodule

RTL LOGIC FOR FLIPFLOPS

TIMING DIGRAMS FOR FLIP FLOPS

RESULTS Thus,the code executed successfully.