sereretec / ph_meter_sensor_esp32_arduino Goto Github PK

this Arduino IDE library is for interfacing the I2C 18bit ADC Sereretec pH Sensor Meter electronics by an ESP, ESP32 or ESP8266 and Arduino.
You can use following commands in the Serial Monitor. The Sensor is based on I2C using a 18bit differential MCP3421 ADC.

cal7
cal6.86
cal4
cal9.18
to change the temp use + or -

confirm with enter.

plus and minus are to set the solution temparature, its normally similar to the ambient temp.
To calibrate, use only 2 points according your calibration solutions.
f.e. pH 7 and 4, or 6.86 / 4, or 7 and 9.18, or 6.86 / 9.18.
The calibration is stored in the EEPROM.
You can enter your solution temparature and the code will atomatically compensate for temp changes.
Please enter the temparature before calibration.
Feel free to replace the temp value with a real temp probe value.

Please see the example file for how to get the readings. this library is tested with an ESP32, for the Arduino 8bit Atmel enviroment you need to uncommnet some lines regarding the EEPROM.