Arduino library to support the IIS2DLPC 3D accelerometer
This sensor uses I2C or SPI to communicate. For I2C it is then required to create a TwoWire interface before accessing to the sensors:
TwoWire dev_i2c(I2C_SDA, I2C_SCL);
dev_i2c.begin();
For SPI it is then required to create a SPI interface before accessing to the sensors:
SPIClass dev_spi(SPI_MOSI, SPI_MISO, SPI_SCK);
dev_spi.begin();
An instance can be created and enabled when the I2C bus is used following the procedure below:
IIS2DLPCSensor Accelero(&dev_i2c);
Accelero.begin();
Accelero.Enable();
An instance can be created and enabled when the SPI bus is used following the procedure below:
IIS2DLPCSensor Accelero(&dev_spi, CS_PIN);
Accelero.begin();
Accelero.Enable();
The access to the sensor values is done as explained below:
Read accelerometer.
int32_t accelerometer[3];
Accelero.GetAxes(accelerometer);
You can find the source files at https://github.com/stm32duino/IIS2DLPC
The IIS2DLPC datasheet is available at https://www.st.com/en/mems-and-sensors/iis2dlpc.html