rewire_pulse_oximeter_firmware's Introduction

rewire_pulse_oximeter_firmware

This repository contains firmware for the ReWire pulse oximeter.

Pre-requisites to building this firmware:

You need a ReWire pulse oximeter device.
The Arduino IDE must be installed.
You must download the ReWire board definitions. Make sure you have the ReWire board definitions added to your Arduino IDE. For more information, go to the board definitions repository at the following link: https://github.com/ReWire-LLC/rewire_board_definitions
Download this repository

After you have met the pre-requisites, take the following steps to build the firmware:

In the Arduino IDE, make sure that you set your "Sketchbook location" (in the Arduino IDE preferences) to be the Dependencies folder of this repository.
Click the compile/build button in the Arduino IDE.

rewire_pulse_oximeter_firmware's People

Contributors

Watchers

rewire_pulse_oximeter_firmware's Issues

Figure out device calibration

Implement calculation of respiratory rate

Just as we should move the calculation of perfusion index to the firmware, we should also implement the calculation of respiratory rate in the firmware.

Get the PPG signal to stream properly

Implement calculation of perfusion index

Currently we calculate perfusion index in the desktop and mobile software. It would be better to move it to the firmware. In that way, all desktop mobile software can easily access that metric without having to calculate it.

Recommend Projects