This is an 8MB Autoconfig Fast RAM for Amiga 500/1000/2000/CDTV based on mkl's mem68k
It's small size allows it to be stacked on top of an ide68k board
Rather than use the original mem68k Abel code I have written a new memory controller in Verilog

1. PCB Ordering
2. Mounting Options
3. Cfgin/out
4. Jumpers
5. CDTV
6. Timing Diagrams
7. Bill of materials
8. Known Issues
9. Experimental firmware

I recommend ordering the PCB with a 0.6 or 0.8mm thickness if you intend on stacking with an ide68k or mouting using a DIP socket/machined pin strips.
If you are going to mount using the socket pins and not stacking with an ide68k I'd recommend going with the usual 1.6mm to reduce flexing.

1. Can be soldered to the bottom of a machined pin socket/machined pin strips (will require some cutting of the dip socket to fit the caps/ferrites near the plastic)

These pins allow you to insert the memory module into your autoconfig chain.
If there are no other autoconfig devices in your system you can just leave these unconnected otherwise you will need to either connect CFGOut to the CFGin of the first device in your existing autoconfig chain, or connect CFGIn to the CFGOut pin of the last device in your existing autoconfig chain.
In the Amiga 2000 you can connect CFGIN to U606 Pin 8 which will add the device to the end of the chain but NOTE: This takes up the config signal for the leftmost slot (CN601) so do NOT install a Zorro card there

You can also connect cfgin and cfgout with a jumper to disable the device temporarily

J1: Cfgin pull up/down (You will probably want to leave this at default unless you know what you're doing)
J2-3: Bridge these if you have not fitted the buffer U4

The CDTV's DMAC takes up the first autoconfig slot, so if you intend to use this with a CDTV use the CDTV specific .JED file to program the CPLD

If you have a Rev A or Rev B (not B1) board you will need to apply a small mod for CDTV compatibility

1. Rev A & B - Incorrect voltage supplied to U4 causes incompatibility with CDTV. Fixed in Rev B1 but you can rework Rev A or B boards by following the instructions here

• AutoSnoop Firmware - Autoconfig after all other Z2 devices without any wires