kuwatay / mocolufa Goto Github PK

Hi!

I'm wanting to switch between firmware's based on a command i can send to the 16u2.
So normally it shows up as a midi controller but when i hit "Update" on my custom avrdude program it switches the firmware on the 16u2 and then updates my 4809 to the latest code.
is this doable with your code?

I have managed to flash the hex file to both my Funduino Mega and Arduino Uno R3 both with 16u2 USB chip and it works great.

I have another Arduino (Genuine) with AT90USB82 USB chip. Can it be flashed with dualMoco.hex somehow? Flip is saying "address out of range"

Hello, is there any possibility of being able to use 2 cables midi?
I know that atmega16u2 has 4 USB endpoints...2 uses them for serial communication, but is it possible to somehow have 2 usb midi devices?thank you
greeting

Who has a solution how to see Serial.println in USB-MIDI mode ?

I'm building this under El Cap OSX. I have tried using Crosspack-AVR and also Brew avr-gcc. I am using the specified version of LUFA. Everything compiles and everything uploads to the atmega16u2 that's on my MEGA2560R3 board.

Problem? The compiled hex file, when uploaded, doesn't allow midi messages to be passed into the computer from the sketch. I've tried mocoLUFA and also dualMocoLufa - same results on both. However when I upload a pre-compiled hex file from the pimp site (online build) - it works fine.

I need to dig into the code in order to be able to implement System Common transmit - I am building an LTC to MTC converter.

I'm not really sure where to start in terms of debugging.

Will this be compatible with the chinese clone nano's with the CH340G chip instead of the 16u2?

Thanks

Will this work on the Atmega 328p on an Arduino Nano?

Thanks!