kornel-schrenk / diveino Goto Github PK

Before the Notes section one line break is missing.

Steps to reproduce - on the surface:

1. In the Main Menu press the Dive button
2. DiveIno switches to Dive Mode without a problem
3. Go back to the Main Menu - press OK on the remote control
4. Press the Dive button once again
5. Switch to Dive Mode fails

The following error message gets displayed in the Serial Monitor:
ERROR: Temporary profile file creation was failed.

DiveIno shows 400-500 minutes deco at 6m, but when the diver pass it (without doing a proper deco) DiveIno shows only a few minutes deco time at 3 meter.

I am not sure it is an issue or not.

After returning from Logbook the battery SOC indicator flickers. It can happen when no battery was attached to DiveIno.

The depth information still gets display when DiveIno switches over from deco to no-deco mode.

In Logbook on the dive profile screen the Zero (0) button press reveals some profile information. This should not happen.

The default minimum temperature should be 100 celsius. Right now it is 0, which indicates too low minimum temperature in dive logs.

The now() function on Arduino Due returns a non-correct timestamp - the number of seconds till the microcontroller board was turned on. It is resulted in wrong surface time calculation. A different timestamp calculation has to be used.

During a repetitive dive a compartment overflow can happen at least on Arduino Mega.