which output of the relay would you connect to the mobo? about auto-hard-reset HOT 9 CLOSED

Hello,

I know there should be a guide, but everytime I forgot to take pictures of the setup when I'm in the farm...

About the high-level connection you are right.
about the other.. each relay have 3 outputs, you should connect to the left and the center one (when they are front of you)
on mobo connect on two pins where you connect the turn on button

If my explanation wasn't good enough I can take a pic of relay which I have here.

from auto-hard-reset.

@Kasmetski, thanks for the follow-up. If it's not too much trouble perhaps you can post a photo of the 5v relay outputs that need to be connected to the mobo. I'm sure it would benefit others who are new to IoT automation.

And, thanks for pointing out the below. This is key:

on mobo connect on two pins where you connect the turn on button

from auto-hard-reset.

I will post pictures with info tonight. Hope it helps. because my setup is working in the farm and I don't have many parts here with me.

from auto-hard-reset.

Thanks. Will be more than happy to update your ReadMe with these clarifications via a pull request. Just give a ping when you're able to post the photos

from auto-hard-reset.

I forgot about the photos. Sorry.
I will take a them when I got home later today.

from auto-hard-reset.

No worries.

What board and parts do you suggest to monitor and control environmental settings such as temperature, humidity, and smoke detection?

from auto-hard-reset.

Looks like I don't have any jumpers at home, but I use simple wires for the picture. You should connect jumpers to this outputs

from auto-hard-reset.

Thanks. When time permits will do a pull request with suggestions/enhancements for your ReadME.

from auto-hard-reset.

Thanks in advance for your contribution.

I'm closing this issue, if there is something else you can write below.
Thanks

from auto-hard-reset.