Setup missing about octoprint-tasmota HOT 4 CLOSED

You're completely right, when I re-designed the interface I totally dropped those fields from the settings. I'll get that added back. I do notice that your IP is configured incorrectly. It should just be the IP address, not the full web url.

from octoprint-tasmota.

Oh..that IP was just an experiment. Thank you!
By the way can i use this plugin if I want a process that - after print is finished - it firstly shuts down the system with proper commands then it turns of the Tasmota-flashed power switch?

from octoprint-tasmota.

New release just pushed to add those fields back in. For your other question, you can achieve this with the GCODE processing, using M81 and the GCODE off delay. This will allow you to add the gcode commands to your end gcode, or within OctoPrint's settings for print complete gcode commands. It will wait for the delay configured after receiving the M81 command and then power off the plug.

from octoprint-tasmota.

Thank you.

from octoprint-tasmota.