jjgraphix / pressureadvancesettingplugin Goto Github PK

Should the pressure_advance value be removed from Klipper's printer.cfg to use this, or does the value specified in Cura alway override this?

What happens if I leave the value at 0 in Cura, will Klipper still use the value in printer.cfg or will it be forced to '0'?

Thanks for creating this!

can't find any pressure advance command in g-code from Cura 4.13 so I created M900 macro, with K-factor from Marlin's linear advance plugin

Hi.

your plugin is very helpful, thanks for the work you put into it!

I use Cura with different printers, some of them do not understand the SET_PRESSURE_ADVANCE line in the G-Code and stop printing.

I tried doing a search & replace postprocessing to delete the SET_PRESSURE_ADVANCE command, but it seems that the line gets inserted after the post processing. So no luck.

Would it be possible to add a setting where you can turn on/off the PA setting per "print setting" and thus the SET_PRESSURE_ADVANCE does not get inserted (and on Klipper printers the Pressure Advance setting of the printer.cfg is used)? This would also prevent existing profiles (where one forgets to update the PA settings) overwriting the printer.cfg setting ;-)

Or could you run the PlugIn before Post Processing is done? The Post Processing scripts are stored per printer, so it would work.

Thx a lot!

I know exactly what my pressure advance needs to be in mm...
what is the factor value multiplying from?

in my case, I am printing at 80mm/sec, and I know my pressure advance needs to be 0.50 for that speed based on a pressure advance test in orca slicer

Does that mean my pressure advance needs to be a factor of .00625?