📊 Wi-Fi Channel State Information(CSI) visualization with python

This repo is based on CSI extracted with Nexmon CSI Extractor(Raspberry Pi, Wi-Fi chip: bcm43455c0).
Therefore, in order to use real-time plot and collect data for visualization, the Nexmon CSI extractor installation must be preceded.
(The csv data required by this repository can be obtained through csi-extractor)

• pcap format is also available(To be implemented)

• Clone this repo and install the dependencies

pip install -r requirements.txt

• If you want to use real-time plot, clone this repo to the Raspberry Pi with Nexmon firmware installed.

python csiexplorer.py [CSI dir] --plt [Plot Type]

• Use sample data for Amplitude-PacketIdx plot

python csiexplorer.py sample --plt 1 --smp true

• Use real-time Amplitude or Phase plot

After installing the Nexmon firmware on the Raspberry Pi and setting the monitoring mode, run the code below.

sudo python3 csi_realTimeAmp.py
or
sudo python3 csi_realTimePhase.py

1. Amplitude-PacketIdx

2. Amplitude-Time

3. Heatmap (Amplitude-Packet)

4. Heatmap (Amplitude-Time)

5. Amplitude-SubcarrierIdx (all packet)

6. Amplitude-SubcarrierIdx Flow (single antenna set)