panasonicsngcja5's Introduction

Panasonic-SN-GCJA5

Introduction

Python driver for Panasonic SN-GCJA5 particulate matter (PM) sensor. Tested on Raspberry Pi Zero/Zero W/3B+/4B

Wiring

Panasonic SN-GCJA5 uses JST SM05B-GHS-TB(LF)(SN) connector and requires 3.3V and 5V for direct wiring. Fortunately, Raspberry Pi GPIOs are 3.3V by default and also supports dual power supply voltages, 3.3V and 5V. Please refer to sensor specification sheet and table below for wiring guide.

Sensor Connector Pin	Symbol	Recommended Voltage	Description	RPi Physical Pin	RPi I/O
Pin 1	TX	3.3V	UART TX (unused if using I2C protocol)	not connected
Pin 2	SDA	3.3V	I2C Data	Pin 3	GPIO2 (I2C1 SDA)
Pin 3	SCL	3.3V	I2C Clock	Pin 5	GPIO3 (I2C1 SCL)
Pin 4	GND	0V	Ground	Pin 6	Ground
Pin 5	VDD	5V	Power supply	Pin 4	5v Power

More details about Raspberry Pi pinout
https://pinout.xyz/

Examples

from time import sleep
from sngcja5 import SNGCJA5


# If SDA and SCL are connected to I2C bus 1, then i2c_bus_no = 1
pm_sensor = SNGCJA5(i2c_bus_no=1)

while True:

    # The get_measurement method returns a dictionary of all measurement value 
    result = pm_sensor.get_measurement()

    print(result)
    '''
    Structure of result
    {
        "sensor_data": {
            "mass_density": {
                "pm1.0": <float>,
                "pm2.5": <float>,
                "pm10": <float>
            },
            "particle_count": {
                "pm0.5": <float>, 
                "pm1.0": <float>, 
                "pm2.5": <float>,
                "pm5.0": <float>, 
                "pm7.5": <float>, 
                "pm10": <float>
            },
            "mass_density_unit": "ug/m3",
            "particle_count_unit": "none" 
        },
        "timestamp": <int> # seconds since the Unix epoch
    }
    '''
    sleep(5)