Sweep is a version of the more fabulous Ferris by Pierre Chevalier that uses a daughter board like a promicro, elite-c, bit-c, nice!nano etc. instead of using onboard components.

^[1] It simply means that it supports the nice!nano. An on/off switch is recommended for bluetooth
^[2] Choc spaced boards have the switches in a tighter grid. This provides a better final look but is only compatible with some choc keycaps (e.g. MBK)
^[3] Supports splitkb's tenting puck
^[4] MX + kailh hotswap ONLY. Alps are NOT supported

• Sweep2 - Recommended Choc v1 board with all the features.
• Sweep Bling MX - An MX only Sweep that features Kailh's hotswap sockets and a stacked case.
• Sweep High - Same as the Sweep2 but trades choc spacing for compatibility with more switches and keycaps.
• Sweep Half Swept - Half of a Sweep2 with double pro-micro footprint (letting you avoid having one daughter-board flipped upside-down)
• Sweep Compact Low - The only version that supports Choc minis.

To build and use a Sweep you will need:

• 1x PCB Kit
• 2x promicro compatible boards or 2 nice!nanos.
• 34 switches of a compatible type (refer to the compatibility table)
• 34 keycaps
• 2x reset switches (optional; B3U-1000P(M))
• Some little rubber feet/bumpers
• 2x power switches (optional if supported; MSK 12C02)
• 1x TRRS (not TRS!) cable (wired build only)
• 2x TRRS Jack [PJ-320A] (wired build only)
• 1 USB Cable (depends on your micro-controller choice)

The firmware can be found with the Ferris firmware as part of QMK.

Firmware for zmk and bluemicro_ble is called "Cradio".

• Pierre Chevalier
• David Barr
• Ibnu Daru Aji
• Duccio