Tool : Crossbreeder
Author : Andrea Coppini
Feedback: Email [email protected] with your feedback.

Crossbreeder is a troubleshooting and automating some simple commonly used tasks for Ruckus APs such as factory reset, update firmware etc. It does not rely on any controller. Instead, it runs through a list of IP addresses supplied by the user to contact each AP directly via SSH. This utility is built for windows and macOS platforms.

Get it from here!

There’s no installer, just unzip and run the exe.

It should be fairly self-explanatory:

1. you feed it a CSV file
2. you set the AP username/password and/or check the ‘also try default’ to use super/sp-admin on factory default APs. (It will try whatever you set first, for example “admin”/”Ruckus123”, and if that fails it will try “super”/”sp-admin”)
3. you choose what you want to do with the APs. It can be any or none of the below:
   1. Change Firmware; to change the AP firmware. (You need to supply your own HTTP, FTP or TFTP server)
   2. Reset AP to factory defaults; same as typing "set factory"
   3. Run a custom command; run any AP CLI command such as ‘set scg ip x.x.x.x’
   4. Reboot the AP; same as typing "reload"
4. If you do not check any of the above 4 options, it will just collect information about the APs and display them in the table.
5. If you wish, you can save the results to a JSON or CSV file.