Any more recent tutorials? about pathcam HOT 4 OPEN

PathCAM hasn't been updated in many years, and Xenovacivus hasn't posted anything to Github in 3 years, and that's on his 'interesting stuff' git. PathCAM has A LOT of bugs. It freaks out over nternational settings(some countries use ',' to separate the fractions from whole numbers, '3,14159' instead of '3.14159' but G-code is supposed to use '.' Gets messy. ) Whatever speed is used is all guesswork. It never seems to be what I want. In some models with holes going through the workpiece it has issues with which side to cut... In one incident it did a 'coarse cut' up to the line, then did a fine cut to clean up the edge of the discard(center of the hole) another, where I had multiple holes, it would cut one 'step down' in each hole before going back to the first and cut another step down... There's a fork of PathCAM, that was supposed to fix the internationalisation, at least, but that hasn't been updated in years, either. you may want to look at GrblGru ( grblgru.com ) It's a CAM program, 3D simulator, G-code sender... Trygve Den 6. april 2023 kl. 19.20.27 +02.00 skrev TTD1024 ***@***.***>: