error usting manual_switch.py about nexa-controller-rpi HOT 6 CLOSED

Usage: on|off data_pin_number transmitter_code

There should be no commas and ‘16’ is not expected.

from nexa-controller-rpi.

ok, thanks. probably a stupid question, but how is the transmitter_code defined?
I suppose he includes the Nexa ID(my case 14072974) and the unit number.

Thanks for your support again :-)

from nexa-controller-rpi.

You have to choose it yourself. Basically choose any number and start the receiver in pairing mode. Then issue “on” command a couple of times with the selected transmitter code. That will make the receiver “remember” your transmitter code.

from nexa-controller-rpi.

ok, I understand (almost, soon), according to http://tech.jolowe.se/home-automation-rf-protocols/, the transmitter-code is different for on/off, but for your version do I have to use always the same transmitter-code?

from nexa-controller-rpi.

Yep, for hardware I used, transmitter code is the same for on/off

from nexa-controller-rpi.

ok, I understand, it seems (in my case NEZCR-1500) that the manual_switch.py is sending to short, as I hear only 2 clicks when I teach it, with the Nexa remote it clicks 3 times.

===> it works, I thank you for your support!

from nexa-controller-rpi.