Size and position configuration about visicam HOT 4 CLOSED

You have to send a calibration job. It will cut two crosses (with the current settings) at (20%/20%) and (80%/80%) of the laser-bed. In the following dialog, you have to take a picture and move the reference crosses matching to the ones you did just cut.

from visicam.

Works! First attempts:
Drawing with a marker, then copied in visicut and engraved. It's offset by about 1.5 mm but that's probably my rough calibration.

Drew a target area with marker, drew a rectangle in VisiCut in it.

Result:

from visicam.

Nice.... that's the way VisiCut was intended. Are you working with the PiCam? I bet you can sell a complete Raspberry with Cam and Software to most VisiCut users...

If you have time, a youtube video would be nice. Not for the setup, but just showing off what you can do.

from visicam.

Yep, the standard module. That's what makes this very universal.
Pictures of the current setup:

I'll think about a video.

from visicam.