Unable to open project about wii-esc HOT 4 OPEN

[deleted comment]

Figured out the problem, all the files were in HTML format. Redownloaded the 
project with tortoise svn and everything is OK, I can compile the project. Now 
I have another issue, I select the corresponding board (RB50A) and flash 
everything when I power the esc instead of beeps the motor is doing some 
strange moves, like it's hitting something over and over again. If I disable 
the startup sounds the motor (NTM 3530 1400kv) starts with a little help but I 
can only go to 15-20% throttle and after that it stalls. I tried SimonK and 
BLHELI and the motor runs Ok but I have problems with very hard acceleration. 
With WiiESc the motor doesn't even start right and if it starts I have the 
maximum throttle issue.

Hi, can you try pre-compilled HEX from here: 
https://googledrive.com/host/0Bzk5pgkwmev-b3ZLaWdQOEJGWUk/

Hi, thanks for the reply but I forgot to mention one thing: I have a DIY ESC 
and the wiring is similar to the RB50A but the high side and low side signals 
are reversed so I cannot use a predefined hex file.