ADK does not work with driver about csr-spi-ftdi HOT 11 OPEN

With the new adk, solder a usb cable to the data pins of the module and connect 5v+ to vin? pin.
Adk config tool works apparently only with usb and not with a spi programmer.
For spi programmer i made one with a stm32 blue pill which works flawlessly.
https://github.com/konsgn/BlueMagic

from csr-spi-ftdi.

you can send the dump, maybe i will get lucky when i do file compare with mine.
thanks!

from csr-spi-ftdi.

The program crashed if you force the name to be "USB SPI" instead of "FT232R xxxxxxxx"
Other utilities work just fine with the changed name.

Maybe there is a check somewhere?

from csr-spi-ftdi.

hello. i have exact same issue. is there any way to fix it? or did you finally order CSR USB SPI programmer?

from csr-spi-ftdi.

I will try it thanks.
I tried once with USB, but my board had 3 USB pins namely USBP, USBN, USB3V3. And it had not worked.
I will leave out 3V3 pin and try with data and 5V for VCC. (I am guessing common ground for USB cable and PCB)
PS: For me UFE and PSTool worked no problem with FT232. (Bluesuite 2.6.8)

from csr-spi-ftdi.

did not work for me yet. as per datasheet, device should have HID(USB) enabled. It is not. and i need ADK config tool for that.
Not sure of drivers too.

from csr-spi-ftdi.

I think that i saw that hid can be enabled somewhere in the pskey tool
Do you get a "Qualcomm qcc300x ..." device when you plug it in?
adk is here: https://www.dropbox.com/sh/o4lyrjb1kq73g4j/AADhk5-PCQSe3aND0PfMa5jga?dl=0

from csr-spi-ftdi.

I didn't get any notification for USB device connection.
I have ADK. I meant that to enable HID I need ADK connected, for which I need HID enabled(deadlock ;).
Okay I will check in PSTool, but yesterday I searched in vain in the Key list.
Thanks!!

from csr-spi-ftdi.

Which chip do you have?
I could send a dump of my qcc3003
Iirc on older versions all values were saved in pskeys (aka spi flash)

from csr-spi-ftdi.

I have QCC3008. if you remember the key name it would be great. i searched for HID and Profile, but did not get a hit.

from csr-spi-ftdi.

Which chip do you have?
I could send a dump of my qcc3003
Iirc on older versions all values were saved in pskeys (aka spi flash)

Can you send your QCC3008 psr dump , please?

from csr-spi-ftdi.