The unit of feed rates are not [mm/m] about linuxcnc HOT 1 CLOSED

Good morning,

Thank you for the heads up; I pushed a fix for this and will mark this closed.

I would be remiss if I didn't point out that the Wikipedia article contradicts itself: "Although not a unit in the International System of Units (SI), the minute is accepted for use in the SI. The SI symbol for minutes is min (without a dot)." It should say something like: "The accepted non-SI symbol for minutes is min (without a dot)." It would also be helpful if it pointed out that the accepted base SI unit is s for seconds.

Have a good day,
Greg

from linuxcnc.