LEDs with push button don't hold up on continuous press about picsimlab HOT 3 CLOSED

Hi @eagl1 ,

your code is correct.
If you're trying to use the PinViewer's toggle button, it only works if you don't have any other connections on the same pin.

If you connect more than one signal source to one pin, the simulator will not work correctly. For example, put two pushbuttons on the same pin or try to use PinViewer to trigger a pin that already has a signal source.

from picsimlab.

If I use PinViewer's alone, it works OK.

But when using push buttons or switches, it doesn't work.

Here's the basic test using only switches and LEDs, so when the switch is in ON state, the output blinks ON for a moment then returns to OFF.

from picsimlab.

If I use PinViewer's alone, it works OK.

But when using push buttons or switches, it doesn't work.

Yes, this is the expected behavior of the circuit. Look at the circuit in the figure below, using two switches in parallel to turn on the LED would cause a short in the power supply. In the simulator, it causes the LED to flash and return to the previous state. This is a condition that should not occur in one circuit.

from picsimlab.