RSP1 - the signal is not recorded correctly (incorrect Sample rate) about urh HOT 6 CLOSED

The bandwidth does not influence the sample rate.

from urh.

Полоса пропускания не влияет на частоту дискретизации.

The bandwidth does not influence the sample rate.

Yes. But there is a bug...

from urh.

I am unsure what exactly the problem is. By the way, you can configure the sample rate of a signal with a click on the (i) button. This is, however, only for displaying purposes (including the calculation of the shown timings).

from urh.

I am unsure what exactly the problem is. By the way, you can configure the sample rate of a signal with a click on the (i) button. This is, however, only for displaying purposes (including the calculation of the shown timings).

Thank you, that's exactly what I do. Only here is the problem with playback, through hack rf (minimal sample rate 2M), and it turns out it does not work correctly. And it's not convenient, you have to set the parameters every time through the (i) button.

from urh.

Well, playback/replay should not work at all using different sample rates for recording and sending, as the data stream is passed to the sending device directly.
However, if you generate this signal, it is possible. I understand your problem as follows:

• you record something with SDRplay and sample rate n
• URH does not set the sample rate you had configured
• bandwidth does not matter as long as you deactivated the lock in the recording dialog. If not, you are going to change the sample rate and this issue has no point.

Do you confirm?

from urh.

Closed due to inactivity.

from urh.