Different travelspeed settings for different axes about cncgcodecontroller HOT 3 CLOSED

Hey J4363R,

what is the use case?
GRBL & Marlin support setting the maximal feedrates.

greetings
Patrick

from cncgcodecontroller.

Hi pknoe3lh,

In the CNC-GCode-Controller there is a setting where you can change the fast move feedrate, but you could only set the value for all axes with the same value and the problem is that the x- & y-axes of my CNC Router could move a lot faster than the z-axis. Oh, and I'am using Marlin, if you need this information. It would be nice if you could add two other buttons so it is possible to set different travelspeeds for the different axes. Or you could add support for the M-Code which sets the fast move speedrate, which would also work for my case.

Best regards,
J4363R

from cncgcodecontroller.

OH I SEE

1. It is a good idear to use the M203 therefore Marlin will caluclate the maximum possible feadrate for you.
2. M203 is not a command used in normal operation ... So its not suppprted. Marlin can save the values in eeprom and so you just have to set them once

So to set M203 just use the communication window. Here you can send what you want ;-)

Greetings
Patrick

from cncgcodecontroller.