Connecting a relay to work with solenoid about fingerprint-mqtt HOT 3 CLOSED

Hiii @unseemlycoder I worked around the problem and got a solution a year back itself and I was a noob back then 😅.. anyway thanks for reminding me to close the issue

from fingerprint-mqtt.

Yes, it's possible. Ideally you could set up an automation on Home Assistant to trigger on match but if you want to execute it within the microcontroller. Assuming relay signal is connected on pin 7 of an esp32:

void setup()
{
// ... //  

  pinMode(7,OUTPUT);
  digitalWrite(7,HIGH);

// ... //
}

uint8_t getFingerprintID() {

// ... //
if (p == FINGERPRINT_OK) {
    Serial.println("Match!");
    lastID = finger.fingerID;
    lastConfidenceScore = finger.confidence;
  
    digitalWrite(7,LOW);
    delay(500);
    digitalWrite(7,HIGH);

    return p;
    }
// ... //
}

from fingerprint-mqtt.

Referenced in #20
Addition of a GPIO pin for relay modulation.

from fingerprint-mqtt.