Cable protection required about exomy HOT 3 CLOSED

Great work! I will have a look on how to add those information to the wiki.
Can you provide some explaining pictures for the parts that needed to be fixed?
It is mostly easier to show stuff, then to explain.

from exomy.

Here are some pictures. You will notice, that instead of opening the motors for cable routing, I added golden motor covers. This saved me some trouble. Currently, the rear bogie has no electrical tape as it the cables never went close to the wheel due to the rubber bands. The electrical tape makes the cables quite stiff. Therefore I tried once to also tape the "exits" from "P28_Wheel_Bracket", but that didn't go to well as the cable was bend not nicely, risking a cable break from the inside.

I currently have the bogie covers on so, sadly no quick pictures of the protected cables through the "P03_Bogie_Bearing".

-> Shows the two different modes for "P29_Wheel_Bracket_Fixing_Plate_Default" for the center wheels.

-> Here you see the cable routing for the center wheels

-> Rear wheel assembly with rubber band alignment. Here two small dropshaped cuts in the "P19_Bogie_Rear Bogie" on both sides to fix the rubber band without my need of a zip tie would make it look even better.

-> Rear wheel assembly with rubber band alignment. You can see here the shrink tube coming out of the wheel assembly. But this is not perfect. I tried stretching the shrink tube to fit it over the connector, so I don't have to cut it open, but with a 2 cm long piece, it was not easy. Maybe a bigger shrink tube could help, but they are currently not part of the BoM, so I didn't have them.

-> Front wheel assembly with rubber band alignment.

-> Front wheel assembly with rubber band alignment and motor cover.

from exomy.

The wiki was updated on the following pages to address this issue:

Purchasing Instructions
Bogie Assembly

from exomy.