On via vol+ after reset about esp32-radio HOT 5 CLOSED

Your config should cantain something like "volume=76" and NOT "mute."
Try to get your display working without the vs1053 connected.

from esp32-radio.

from esp32-radio.

Hi, All must be,

I tested the TFT display with the benchmark file as found in the ILI9163c zip and it works on a NANO.
A small stroke was not used!
Than I connect the display again to my radio and disconnect fully the VS1053( Alientek) no picture at all a clear white screen. Double checked the connections.
Compaired to the both files the benchmark.ino and the ESP32Radio.ino there is some slide difference in defining the CS and DC
#define TFT_CS 15
#define TFT_DC 2 ESPRadio.ino ( yours so to say )

#define __CS 10
#define __DC 6 benchmark.ino

I.am not meaning the i/o number.

Can this make the difference?
What exactely you mean with the "bleu 1.8 SPI 128x160 board" in your documentation?
I can only found a red or black board

I,am cont. to have my display working.
Your advise is highly appreciated.

Kind regards,
Theo

from esp32-radio.

I used this one: https://www.aliexpress.com/item/Smart-Electronics-1-8-Inch-128-160-Serial-SPI-TFT-LCD-Module-Display-PCB-Adapter-Power/32597366825.html?spm=2114.13010608.0.0.cqL62P.

Make sure your power supply is strong enough. The ESP32 is very sensitive on this.
The GPIO pins are correct in the ESP32-Radio sketch. If you have a Voltmeter, both TFT_CS and TFT_DC should be HIGH normally.

from esp32-radio.

Hi, all

Succes. I must admit it is fully my fault. As "penny wise pond foolish". I used a experiment pcb from a former project and some copper traces where still open D15 among them. This solved and tested my set-up and display gives nice data in full collor.
Now I have to find out if the power supply is 100% relaiable in combination with sufficient voltage and current, I,am using a 6 volt 400mA power supply 3.3 volts by a LD33VC 1amp, also related to the used capaciters.
I also have to check the volume setting as default mute is not the meaning.
Ed, many thanks for your support.
As far as I can check I have the same display as mentioned.
Kind regards,
Theo

So far So good I,am realy trilled by this project.

from esp32-radio.