Initialization Test about andes HOT 5 CLOSED

ANDES has an initialization test right after initializing the time-domain simulation. In fact, you can enable the initialization of all dynamic models following power flow. It can be done by editing the config and setting init_tds = 1 under [PFlow].

With the setting on, you can test if initialization is ok by andes run your_case_with_new_model.xlsx. Pay attention to the Initialization for dynamics was successful or Suspect initialization issue message.

from andes.

I thought about a feature to allow testing individual models without relying on a test system. It will instead rely on pre-defined numbers from the user. This is closer to the concept of unit test, but I haven't had the time to do it.

from andes.

ANDES has an initialization test right after initializing the time-domain simulation. In fact, you can enable the initialization of all dynamic models following power flow. It can be done by editing the config and setting init_tds = 1 under [PFlow].

With the setting on, you can test if initialization is ok by andes run your_case_with_new_model.xlsx. Pay attention to the Initialization for dynamics was successful or Suspect initialization issue message.

Okay, I didn't notice that. I'll keep this tip in my ANDES Development: Entry to Enhancement.

from andes.

I thought about a feature to allow testing individual models without relying on a test system. It will instead rely on pre-defined numbers from the user. This is closer to the concept of unit test, but I haven't had the time to do it.

Yes, ANDES is built with great efforts, but it is true we have really limited resources.
Hope we can get more support in the future.

from andes.

Thanks. If the solution works, I will close the issue for now.

from andes.