Add support for setting room setpoint about home-assistant-bosch-custom-component HOT 5 CLOSED

Missing installation info.
Provide bosch_scan.
In what operation_mode this setpoint should be set?
In most cases in RC35 this URI doesn't work. You need to set temperatureLevels/day to set temperature.

from home-assistant-bosch-custom-component.

rawscan.txt

Attached the rawscan. I have it in operationMode manual.

from home-assistant-bosch-custom-component.

Anything about your installation?
What do you have inside? Heater, I see RC300, what else?

What's the trouble. I see RC300 in your setup, same firmware as everybody, but you have different operation modes for HC1 and DHW.

DHW have in my setup:

• ownprogram
• high
• Off
• HCprogram

And in yours:

• Off
• low
• high
• ownprogram
• eco

Anyway I will try to add those operation modes for you as well.

About HC1 - it should work. In manual mode it is sending temp to /heatingCircuits/hc1/manualRoomSetpoint.
Try to fetch some logs, so we can find out why HC1 is not working as expected.

from home-assistant-bosch-custom-component.

I have a Bosch air-to-water heat pump. I think it has a variant of the RC300 that is called HPC400 in Sweden and Norway.

https://www.bosch-climate.se/globalassets/content-images/dokumentbibliotek/handbocker/luftvatten/anvandarhandl_hpc400_600_6720820629_01.pdf

from home-assistant-bosch-custom-component.

I have verified setting room temperature with HC1 is ok with component version 0.7.0 and HA 0.105.0. Thanks!

from home-assistant-bosch-custom-component.