Weird scan pattern about dmd_stm32 HOT 10 CLOSED

#define DISPLAY_TYPE 2,32,16,2,1

try this variants:

2,32,16,2,2
2,32,16,2,3
1,32,16,2,2
1,32,16,2,2

from dmd_stm32.

Do you want recording from there or just a plain "works/doesn't"?

from dmd_stm32.

If any of them will run more than 2 pixels horizontally in a serie...

from dmd_stm32.

With 1 mux line, the pixels get two levels of brightness (or something like that) after some time

2,32,16,2,2

2,32,16,2,3

1,32,16,2,2 (this was mentioned twice by you, on purpose?)

from dmd_stm32.

Disconnect the "B" line from the STM and connect B pin on the HUB to GND permanently. Than run the pattern 1,32,16,2,2 again. Will it run up to full panel width? The more long video could be useful

from dmd_stm32.

Again I'm using a PCB here, so no way to change connections. Will try when I set up another board.

from dmd_stm32.

Connecting B to the GND is not the main thing; when selecting one pin mux , the B pin should already have a low level.
The main thing is: do the pixels go to the end of the panel?

from dmd_stm32.

Hi, did you resolved the problem?

from dmd_stm32.

Not yet, didn't have time to give it my proper attention since the last time :(

from dmd_stm32.

Ok,
If you will need my help, write.

Merry Christmas!

from dmd_stm32.