connection BTTSKR e3 V3 to TFT35 V3.0.1 impossible in Marlin mode about bigtreetech-tft35-v3.0 HOT 13 CLOSED

Sorry i forgot for the others persons who have the same problem i set marlin_type: to 1 into Config.ini file of the screen.

from bigtreetech-tft35-v3.0.

IT works !
Your are brilliant !
Thanks a lot for your help.
José

from bigtreetech-tft35-v3.0.

You have to connect the 10-pin cable to the EXP3 connector.

Send a photo of the wiring.
Send Marlin configuration files.

from bigtreetech-tft35-v3.0.

Hello,
as i mentioned above i have tried to connect the stock 10 pins cable to EXP3 and doesn't work at all.
here you are my config files.

Configuration.h.txt

Thanks a lot

from bigtreetech-tft35-v3.0.

Hello some photos of the wiring


Have a nice day
José

from bigtreetech-tft35-v3.0.

You misconnected the 10 pin connector. On one side, turn it 180 degrees.

from bigtreetech-tft35-v3.0.

from bigtreetech-tft35-v3.0.

There are several solutions to your problem.

• you can cut the protrusion as you write, or you can
• make a new cable with the correct orientation, or
• turn the opposite piece. (pull off the pins and put on in reverse)

from bigtreetech-tft35-v3.0.

Super i am going to try it
thanks

from bigtreetech-tft35-v3.0.

:( I rotated the connector (solution 3) as you said but the screen display "Marlin mode" and black screen .
More idea ?
Merci

from bigtreetech-tft35-v3.0.

Marlin's mod should work.
Send your display configuration
config.ini

from bigtreetech-tft35-v3.0.

I haven't got any .the firmware is stock firmware. I'm going to flash a new one and i'll go back tomorrow. I must buy a SD card.
Thank's and have a good evening (or a good day ?).
José

from bigtreetech-tft35-v3.0.

In Marlin you have to enable
#define CR10_STOCKDISPLAY

You configure TFT with the Config.ini file.
you must have an active choice
marlin_type:0

from bigtreetech-tft35-v3.0.