Problem with homing with 2 motor about fluidnc HOT 4 CLOSED

Here there are a video Showing the problem

from fluidnc.

Are you 100% sure the switches are associated with the right motors? Many people have the motor0 switch on the Motor1 side by accident and the behavior is not right.

from fluidnc.

Your video will not play for me, nor will it download. I tested 3.7.17 with my dual-y-motor laser gantry, on a Fysetc E4 controller, and squared homing worked perfectly. If you send $message/level=debug , you will get lots of homing progress report messages that might help.

from fluidnc.

Hello,

After updating the software to version 3.7.17 and conducting more tests on the software, I decided to check with the oscilloscope and found the problem. The signal for the direction was not turning due to a bad connection to the direction pin of the Y-axis Motor 0. I just need to apologize for the time I've made you lose as it was a hardware issue. Thank you very much for your help.

from fluidnc.